Riello RS 70/E MZ Manuel d'instructions télécharger pdf (Page 16)

Installation

Once the combustion head adjustment is completed:

³ reassemble the burner on the guides 3) at about 100 mm

from the pipe coupling 4) - burner in the position shown in

Fig. 11;

³ insert the probe and electrode cables, then slide the burner

as far as the pipe coupling - burner in the position shown in

Fig. 18;

³ connect the plug of the servomotor 14) (Fig. 11) and tighten

the cable grommet 15) (Fig. 11);

³ connect the socket of the maximum gas pressure switch;

³ refit the screws 2) on the guides 3);

³ fix the burner to the pipe coupling with the screws 1).

When fitting the burner on the two guides, it is

advisable to gently draw out the high voltage

cable and flame detection probe cable until they

are slightly taut.

CAUTION

Fig. 18

D7975

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Pas de commentaire

Riello RS 70/E MZ Manuel d'instructions Page 16